3D 1000 Large Format Printer

Owned by Imagine That

Last updated: Jan 13, 2023

3 min read

Firmware:

Printer Profiles (S3D):

Molex crimp part numbers for 3D 1000

Molex Microfit 3.0 series.

Crimp pins:

Female pin: 43030-0001

Male pin: 43031-0001

Connector housings:

2-pin receptacle: 43645-0200

2-pin plug: 43640-0201

4-pin receptacle: 43645-0400

4-pin plug: 43640-0401

Crimping tool:

63819-0000

Motor coupling change process

Dismounting:

Loosen the clamp screw (E1) and remove the coupling.
Use an appropriate tool that will not damage the coupling to pry the coupling halves apart.

Mounting:

Slide a coupling half onto the shaft to the correct axial position.
Using a torque wrench, tighten the clamp screw (E1) to 2Nm.
Insert the elastomer ring and press the two coupling halves together. Ensure that the fit length (A) is maintained at approximately 10mm.
Mount the assembled coupling onto the second shaft and tighten the clamp screw (E1) to 2Nm.

3D Printed Production Parts

Preview:

Description:

Download Link:

60mm Fan grill (used for electrical and control box fans)

200 Series Z home sensor mounting bracket

300 Series Z home sensor mounting bracket

Bed temperature LED light mount

200/300 Series glass bracket

HFE 300 extruder fan shroud

(only for fans mounted on the extruder itself, not on the machine)

BL touch mounting bracket

(For machines without the electrical tower mounted on the back)

Latest - BL touch mounting bracket

(For machines with the electrical tower mounted on the back)

Latest - Touchscreen bezel (for integrated screens only)

Z axis motor/wire cover

200/300 Series part cooling fan duct (left side)

This part should be printed at a 45 degree angle without support material by placing the flat surface (with triangular holes) down on the build platform.

200/300 Series part cooling fan duct (right side)

This part should be printed at a 45 degree angle without support material by placing the flat surface (with triangular holes) down on the build platform.