Raptor Wiring

Owned by Imagine That
Dec 04, 2020
2 min read

  1. Connect X axis Cables 

The 3pin cable is for X axis limit switch, the 4 pin cable is for X axis motor. please connect themtoswitch box. 

  1. Connect Z axis Motor Cables

  1. Connect LED Light Cable 

  1. Connect DB Cable to Extruder 

Please take out DB cable and screwdriver from carton.

Connect DB cable to electrical box, then lead it to the extruder from the middle of two filament spool holders. (Note: you can fix DB cable into the slot of spool holder.)

Tighten the screws of DB cable by screwdriver, so as to avoid loose contact during printing.

meanwhile, fix DB cable onto aluminum extrusion by zip ties.

Finally, put the ring-pull of spring cable into filament spool holder. 

  1. Connect Power Cords 

There are two power cords, one for printer, which is plugged to the switch box at back. Another one for heating pad, which is plugged to the switch box under print bed.